Aiwa FR-C150 Manual de Serviço descarregar pdf (Página 2)

CX-JN331/JPK331

General

Power requirements

Mexican models: 127 V AC, 60 Hz

Other models: 120 V, 220 V or

230 − 240 V AC, 50/60 Hz

Adjustable with voltage

selector

110 watts

Dimensions (w/h/d) incl. projecting parts and controls

Amplifier/Tuner/Tape/CD section:

Approx. 280 × 325 ×

425 mm

Power consumption

Mass Approx. 8.3 kg

Design and specifications are subject to change

without notice.

Notes on chip component replacement

• Never reuse a disconnected chip component.

• Notice that the minus side of a tantalum capacitor may be

damaged by heat.

Flexible Circuit Board Repairing

• Keep the temperature of the soldering iron around 270 ˚C

during repairing.

• Do not touch the soldering iron on the same conductor of the

circuit board (within 3 times).

• Be careful not to apply force on the conductor when soldering

or unsoldering.

This appliance is classified as a CLASS 1

LASER product.

This label is located on the rear exterior.

CAUTION

Use of controls or adjustments or performance of procedures

other than those specified herein may result in hazardous radiation

exposure.

SAFETY-RELATED COMPONENT WARNING!!

COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE

WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN

THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.

REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE

PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR

IN SUPPLEMENTS PUBLISHED BY SONY.

1 2 3 4 5 6 7 ... 79 80

Sem comentários

Aiwa FR-C150 Manual de Serviço Página 2